table of contents
| NTPLOGTEMP(1) | NTPsec | NTPLOGTEMP(1) |
NAME¶
ntplogtemp - log temperature data
SYNOPSIS¶
ntplogtemp [-h] [-l LOGFILE] [-o] [-w WAIT] [-v] [-V]
-h, --help show this help message and exit -l LOGFILE, --logfile LOGFILE
append log data to LOGFILE instead of stdout -q, --quiet be quiet -o, --once log one line, then exit -w WAIT, --wait WAIT wait WAIT seconds after each log line, default 60 -v, --verbose be verbose -V, --version show program's version number and exit
DESCRIPTION¶
ntplogtemp gathers temperature readings across a system. The standard user is ntpuser and should have permissions to execute lm_sensors and smartctl.
The default is to write the data to stdout once every 60 seconds. The log file looks like:
# time, sensor, value 1485816568 ZONE0 39.0 1485816568 ZONE1 20.0 1485816568 ZONE2 42.0 1485816568 ZONE3 0.0
Time is the POSIX time of when the log line is written.
Sensor is the sensor the temperature reading was obtained from.
Value is the temperature reading in celsius.
OPTIONS¶
-h, --help
Displays usage information and exits.
-l LOGFILE, --logfile LOGFILE
Append log data to LOGFILE instead of stdout
-q, --quiet
Quiet output, will not display errors
-o, --once
Log the data once, then exit
-v, --verbose
Be verbose
-w WAIT, --wait WAIT
Wait WAIT seconds after each log line. The default is 60
seconds. The minimum wait time is 5 seconds.
-V, --version
show program’s version number and exit
USAGE¶
ntplogtemp
This the simplest use of this program. It can be used to
check the temperature readings of Zones, CPU, and disk drives every
minute.
ntplogtemp -l /var/log/ntpstats/temperature -w 60 &
This will continuously log the temperature data in the
background to the file /var/log/ntpstats/temperature. Only log every 60
seconds.
AUTHORS¶
Gary E. Miller
Keane S. Wolter
EXIT STATUS¶
One of the following exit values will be returned:
0 (EXIT_SUCCESS)
Successful program execution.
1 (EXIT_FAILURE)
The operation failed or the command syntax was not
valid.
| 04/17/2024 | NTPsec 1.2.3 |