NAME¶

library_contents - Configuration file for vtllibrary(1)

DESCRIPTION¶

Configuration file for vtllibrary daemon (part of Virtual Tape Library) One line per entry. Contains the following sections, Only the 'Slot' section should be populated with additional information (barcodes). The other sections are used as place holders. e.g. If the number of MAP slots are to be changed within the VTL, change the number of entries in this configuration file.

Drive #:

Note: Set the serial number of the drive in device.conf

Picker #:

MAP #:

Slot #: [Barcode]

Where [Barcode] can be any ASCII string from 1 to 12 chars in length. If there is no Barcode defined for the Slot number, the slot is taken to be empty.

AUTHOR¶

Written by Mark Harvey

BUGS¶

REPORTING BUGS¶

Report bugs to <markh794@gmail.com> <mark.harvey@nutanix.com>.

COPYRIGHT¶

Copyright © 2005 Free Software Foundation, Inc.
This is free software; see the source for copying conditions. There is NO warranty; not even for MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.

SEE ALSO¶

make_vtl_media(1), mktape(1), vtlcmd(1), vtllibrary(1), vtltape(1) device.conf(5)